Enhancement 86 27 Pin MU Tester

Simple Operation

110 Volt Required

Class 1 Approvals

Operation instructions:
1. Plug in the Power Cord.
2. Turn the selector switch on the right side of the box to the on position.
3. Wait for the operator interface to power up and run a self-test.
4. When prompted by the display, press the Escape key. The display will show Ready to Start Test
5. Plug the Jumper Cable into the connectors on each side of the tester.
6. Press F1 to start the test. The display will show Test in Progress
7a. If the cable is good, when the test is completed the display will show Test Passed.
Removing the Cable from the tester will display Ready to Start Test again.
7b. If the cable fails the test, all faults such as open or crossed wires will be displayed.
Pressing the F2 key will reset one fault at a time, allowing identification of the reason the Cable failed,
until all of the faults are reset.
NOTE: Pressing F3 will abort a test in progress at any time and allow all faults to be reset by pressing F2 only once.

PowerRail P/N MAE-05 Tester	PDF Download

27 Pin MU Jumper Cables	MU Covers and Receptacles	MU Head Parts	Hose Hangers
Safety Release Jumper Cables

Back to Enhancements

Back to Products